Reaper Stem Install on KHS DJ300

Articles Products

Was finally able to locate a bar for the Reaper Stem. I found out the hard way you have to put the front 2/3 together first, then install that on the back clamp. If you don’t you won’t have any room to tighten these bolts. Guess directions are there for a reason.


Putting on the bar was a snap. Boy do I love guide marks! Makes it so easy to center the bar on the stem.

I think I was subconsciously turning those eyes away from me as much as I could. Didn’t want to stare the reaper in the face.

I can honestly say I though this stem was going to look a little over-the-top. But once it was installed and paired with the Dirty Dog skull rotors I think it finished off the build rather nicely. Now I just have to find some time to test this behemoth.

RL Policar

RL Policar is an avid mountain biker and the Editor In-Chief of MtnBikeRiders.com and BikeCommuters.com. Between the two sites, he's published well over 4,000 articles (and growing).

https://www.mtnbikeriders.com

6 thoughts on “Reaper Stem Install on KHS DJ300

  1. DAAANNNGGGG! That ride is wicked sweet Lance!!!! And I don’t say that very often! Can’t wait to see what you can do with that out on the trails!! 😀

Leave a Reply

Your email address will not be published. Required fields are marked *